SterlingKey™ Forum

What's new:

• SterlingKey™ now uses the Vendor ID and Product ID of the connected device. This might allow software to detect the device even behind SterlingKey™. Not fully tested with many keyboards, Microsoft Natural Ergonomic Keyboard 4000 was detected successfully and remapping of keys was possible
• There was an issue with mice which did not allow sending the same command twice in a row (i.e. scroll down and then scroll down again). This is now fixed
• Enabling/Disabling slots to skip slots while cycling between them. If for example you only care about slot 1 and 2, and want to skip 3 every time, you can disable it

How to Enable/Disable slots:

1. Visit updater
2. Under 'Console', select 'Start'
3. Select the device
4. In the input field, the following commands are available:
   • disable slot 1 (to disable slot 1, likewise for 2 and 3)
   • enable slot 1 (to enable slot 1, likewise for 2 and 3)
   • get slots (shows the current state of all 3 slots)
5. Click 'Enter' or 'Send' to apply the changes.

If you encounter any issues or have feedback to share, please don't hesitate to contact me.
How to update