Firmware Version 1.1.0 released

Locked
Alex
Site Admin
Site Admin
Posts: 37
Joined: Sun Jan 21, 2024 1:37 am

Firmware Version 1.1.0 released

Post by Alex »

What's new:
  • SterlingKey™ now uses the Vendor ID and Product ID of the connected device. This might allow software to detect the device even behind SterlingKey™. Not fully tested with many keyboards, Microsoft Natural Ergonomic Keyboard 4000 was detected successfully and remapping of keys was possible
  • There was an issue with mice which did not allow sending the same command twice in a row (i.e. scroll down and then scroll down again). This is now fixed
  • Enabling/Disabling slots to skip slots while cycling between them. If for example you only care about slot 1 and 2, and want to skip 3 every time, you can disable it
How to Enable/Disable slots:
  1. Visit updater
  2. Under 'Console', select 'Start'
  3. Select the device
  4. In the input field, the following commands are available:
    • disable slot 1 (to disable slot 1, likewise for 2 and 3)
    • enable slot 1 (to enable slot 1, likewise for 2 and 3)
    • get slots (shows the current state of all 3 slots)
  5. Click 'Enter' or 'Send' to apply the changes.
If you encounter any issues or have feedback to share, please don't hesitate to contact me.
How to update
Locked